Get notified via email whenever a new firmware or ROM file is added. Go here to register your email address.
0 votes
in Hurricane by

good day

i flashed hurricane freedom using the rom provided by satech after flashing is done the screen is showing blank, and i did not flash with preloader ticked now when i try flashing it again it says please make sure the load matches the target.

any help is appreciated

thank you

1 Answer

0 votes
by (63.4k points)
Hi Sir. What was the issue with the tablet at first? Depending on what the issue was, it may have been necessary to format whole flash (except bootloader). Also, did you already try a memory test to see if the RAM and EMMC are in place. I will also suggest you open the back cover and note down and share the board ID of the device. Please use the reply button to share the above desired information and I will try and assist further.
by (120 points)
the problem it had was it was not installing whatsapp and the whatsapp it had was installed under system apps so i rooted the phone and deletd the whatsapp and unrooted the tab again but when i connected it to the network a virus got installed n it kept adding apps so i decided to format it and reload software on it i used flashtool to format it and loaded the file without preloader ticked and it gave me blank screen.

thanks kervin
by (63.4k points)
Understood Sir. May I know how exactly you proceeded with the formatting part? Also, please do share the board ID
by (63.4k points)
And do you get any error code with the error message you receive when trying to flash again Sir?
by (120 points)
no i dont get any message anymore it flashes complete but da lcd stays white.
by (120 points)
i formatted it using auto format and format whole flash xcept bootloader, and where do i find the board id?
Saroms HELP, where you can avail support on files purchased through saroms or request any other Chinese lowend firmware or file not yet listed on www.saroms.co.za.
...