Get notified via email whenever a new firmware or ROM file is added. Go here to register your email address.
0 votes
in Stylo by (68.2k points)
edited by

On the answer section below is a step by step guide on how one can reload or flash the Stylo S53 Stark device firmware or ROM file. Since this device is not a secure boot, the flashing process should be quite that standard one for MediaTek SoC based devices. But if you are somewhat new to Android firmware flashing, then the below guide should be of much help.

1 Answer

0 votes
by (68.2k points)
 
Best answer
  1. Click on the Scatter loading button from the Sp Flash Tool interface
  2. Navigate to the downloaded and extracted ROM or firmware folder through the window that pops up and select the scatter text file from there
  3. Untick the preloader (and all others that you may wish to not flash if any).
  4. Ensure 'Download only" is set and not any other mode
  5. Click Download - remove and replace the battery from the Stylo S53 Stark
  6. Connect the device to the PC through a USB cable WITHOUT pressing any key
  7. You get a red, purple and then yellow progress bar - the yellow one will proceed for some time
  8. Once done, you get "Download OK" with a tick
  9. At this stage you can disconnect the device and attempt to power it on
  10. If it hangs on the logo screen for much longer, you can boot into recovery and wipe userdata and then retry booting it up again

Please ask any question you may have on this on the comment section below and I should gladly assist or clarify further

Saroms HELP, where you can avail support on files purchased through saroms or request any other Chinese lowend firmware or file not yet listed on www.saroms.co.za.

Categories

...