Get notified via email whenever a new firmware or ROM file is added. Go here to register your email address.
0 votes
in ClickTab by (64k points)
edited by
If you are looking for a ROM, formware or flash file for the 7 inch ClickTab M7043G Android 5.1 tablet, then below you should find instructions on where you can order it as well as a guide on how you can flash it onto the device.

1 Answer

0 votes
by (64k points)
Best answer
  1. Yoou can purchase and download the firmware or flashfile for the ClickTab7" M7043G from here:
  2. Download the recommended SP Flash Tool version from here:!7UATVAiQ!B4xhV7D6H2rLzIPaebkYXUzDgZkuMy0Bimw_Ltcet9I and extract and lauch it
  3. Click on the Scatter loading button
  4. Navigateto the downloaded and extracted ROM or firmware folder and select the scatter text file from there
  5. Untick the preloader
  6. Ensure 'Download only" is set and not any other mode
  7. Ensure the tablet is on off mode - you may have to remove the back cove and disconnect and reconnect one battery cable if the tablet is stuck on for some reasons
  8. Connect the device to the PC through a USB cable WITHOUT pressing any key
  9. You get a red, purple and then yellow progress bar - the yellow one will proceed for some time
  10. Once done, you get "Download OK" with a tick
  11. At this stage you can disconnect the device and attempt to power it on
  12. If it hangs on the logo screen for much longer, you can boot into recovery and wipe userdata and then retry booting it up again

Please ask any question you may have on this on the comment section below and I should gladly assist or clarify

Saroms HELP, where you can avail support on files purchased through saroms or request any other Chinese lowend firmware or file not yet listed on